4in Line Voltage Air Tight Remodel Housing for Recessed Lighting
Buy 6 or more. Save 5%.
Out of Stock
- Use PAR16 or PAR20 halogen
- Order lamp separately
- Maximum watts: 50
- UL listed, damp locations
- Several Knockouts: junction box has four 1/2in knockouts, two 3/4in knockouts, and four more knockouts with true pry-out slots
Shop More Nora Lighting Products
- (8) 5 star reviews
- (4) 4 star reviews
- (2) 3 star reviews
Easy to install
Submitted by Misty | 1.25.17
Submitted by Tamy | 7.24.14
Price is very reasonable
Submitted by Alex M. | 7.25.13
Durable, impressive quality, easy installation
Submitted by Joshua | 3.07.12
Nice solid can Wires nicely
Was not what it was advertised to be. Listed as IC originally on website but has since been corrected to just air tight.
You can count on Pegasus for great products and service!
Submitted by AdmiralT | 1.02.12
Don't know why you would want to spend more
Submitted by John L | 10.31.11
Clamping system took a bit to figure out.
Question from Alexander:
Answer from Pegasus:Since it's suitable for damp locations you should be OK because it's protected from direct water spray under the soffit.
Question from Hanae:
Answer from Pegasus:I do not know of any reason why this housing would not install in an old home. The only limitation is that it cannot be in contact in ceiling insulation.
Question from Roq:
Answer from Pegasus:IC Rated means that you can put insulation up against the housing. If the housing is not IC rated, you must hold the insulation 3 inches away from all surfaces.
Question from Conner:
Answer from Pegasus:This 4 inch Line Voltage Housing requires a PAR20 or a PAR16 MIni Lamp. A Standard 120-Volt Screw Base LED Lamp can be used however some LED Lamps are larger in diameter than a standard PAR lamp and might not fit the inside diameter of a Trim.
Question from Mike:
Answer from Pegasus:D-12DL4-827-BT-WFL-D is designed to fit a standard 4 inch line voltage housing. The manufacture recommends a CFL-LED Dimmer.
Question from Tanner Spears:
Answer from Pegasus:This housing is intended to mount against drywall or plaster ceiling 1-1/4" in thickness.