3.9W LED Dimmable Indoor-Outdoor Step Light with Rectangular Scoop
Buy 6 or more. Save 5%.
Usually ships the next business day
- Indoor or outdoor
- Warm white light
- 40,000-Hour life
- Only 3.9 watts
- LED Step Light: includes the faceplate and the LED light engine.
Required Components Sold Separately
- Junction Box: easily installs in a 2in x 4in junction box with minimum inside dimensions of 2in(H) x 2in(W) x 3in(L) (purchased separately - generally found in most electrical supply stores). Direct wiring, no driver needed.
Shop More WAC Lighting Products
No reviews yet
Be one of the first to Write a review.
Question from John:
Answer from Pegasus:No, I would not recommend installing in the floor. These step lights are meant for installation into walls only.
Question from Steve Wichmann:
Answer from Pegasus:Steve, no we do not have photometrics for the step lights.
Question from Peter:
Answer from Pegasus:Peter, the manufacturer recommends spacing every 3ft and keeping the lights 1-1.5ft above the ground.
Question from Peter:
Answer from Pegasus:Peter, I spoke with WAC Lighting, the manufacturer, about the dimming and minimum load issue. In general, Lutron's ELV dimmers require a min load of 40W. If you do not meet that load requirement, WAC suggests using Lutron's Skylark SELV-300P. WAC has tested this specific dimmer with a single step light and found it dims from 100-10% without issue. Since you intend to install 7 step lights, which is below the 40W min load, I would advise using the Skylark dimmer. I hope this helps!
Question from Jim:
Answer from Pegasus:Jim, you need to use an ELV dimmer - The dimmer will connect to your line voltage and then in turn connect to the light fixtures. The step light has a built in driver (similar to a transformer) and WAC Lighting, the manufacturer, recommends dimming with ELV dimmers.
Question from Francis Robin:
Answer from Pegasus:Francis, For best dimming performance, you'll need to meet the dimmer's minimum wattage requirement. For example, if the dimmer requires a minimum load of 30W, then you would need to connect 8 step lights to the dimmer.
Question from Mike:
Answer from Pegasus:Mike, It installs in a 2in x 4in junction box with minimum inside dimensions of 2in(H) x 2in(W) x 3in(L).
Question from Rose:
Answer from Pegasus:Rose, yes you can install a single light.The manufacturer recommends using Lutron SELV-300P for dimming a single step light.
Question from Mariana:
Answer from Pegasus:Per the manufacturer, this step light is wet location rated to IP66 standards for indoor and outdoor installations. Please refer to the installation instructions for proper outdoor installation.https://www.pegasuslighting.com/files/pdfs/led-step-light-rectangular-scoop-4w-120v-install-instructions.pdf
Question from Amy:
Answer from Pegasus:As per the manufacturer the Stainless Steel version can be used in concrete applications. https://www.pegasuslighting.com/led-step-lights/39w-led-dimmable-indoor-outdoor-step-light-with-rectangular-scoop.html
Question from Randy:
Answer from Pegasus:Very sorry the manufacturer makes only up to a 5.25 inch diameter.