By Judi from Dallas, Texas on November 17, 2012
We have a can light now and are trying to install an LED light. It states in the directions to put the torsion springs into the mounting bracket - is this what we mount inside the can light hole before installing the LED light?
By Jacob from Pegasus Lighting on November 19, 2012
If your LED light has torsion springs AND your recessed can DOES not allow for the installation of torsion rings, then yes, this adapter will allow the installation of your LED light in 6-inch cans.
By Omer from Dublin, California on May 18, 2014
How does this adapter need to be secured in the can?
My can lacks the torsion spring ears, that's why I need it, but it also does not have any holes or screws to hold any adapter.
By Jacob from Pegasus Lighting on May 19, 2014
Answer:Omer, this bracket will attach to a can via spring clips, screws, or friction blades.
By Everard from New Orleans on May 19, 2014
Answer:The wings on the outside push against the opening. There are also little holes every 90 degrees that you can put long thin nails into radiating outwards. Also in some instances, we put small blocks of wood and used wood screws to fasten the rim to.
By Seth from Albany, NY on May 19, 2014
Answer:You don't need any screws, the silver springs as shown in the picture hold it in with tension.
By Matt from VA on July 4, 2013
Will these work with Lightolier 6-inch housings?
By Jacob from Pegasus Lighting on July 8, 2013
It may fit but the only way to know for certain is to test it. This product is specifically designed for use with Nora Lighting LED retrofits installed in L or P style 6in housings.