By Bill from Winnipeg, CA on April 1, 2013
If these are ceiling retro fitted and mounted, how do you maintain the integrity of the ceiling vapor barrier?
By Jacob from Pegasus Lighting on April 1, 2013
Thanks for the question.
The vapor barrier would have to be cut in order to install these. If you use a compatible wet location housing, then the recessed light should be perfectly suitable for wet locations.
Whether the vapor barrier would be compromised, I honestly do not know. I would think the goal would be to seal the barrier around the recessed light, with caulk or some other method.
I would strongly suggest contacting an contractor who is knowledgeable of local building codes.
By Jonathan from Miami, Florida on July 22, 2014
Is this fixture dimmable?
By Jacob from Pegasus Lighting on July 23, 2014
Answer:Yes, it's dimmable.
By Gary Simms from Canada on July 29, 2014
What is the trick to unscrew halogen bulb?
By Wayne from Chicago on July 30, 2014
Answer:I have four of these fixtures in our kitchen. No tools needed. Turn off power to light; otherwise halogen bulb will be hot. Using both hands, simply place fingernails under opposite sides of trim ring and pull down gently to expose bulb. Slip edge of bulb out from the clips that secure it to the trim ring. There is a standard light socket at the top inside of the housing; unscrew the bulb as you would a table lamp. You can replace with an LED bulb if you want. They cost more but last much longer, generate less heat and use a fraction of the energy of halogen.
By Daniel from Montreal, Qc on May 29, 2013
What is the size of the opening for this trim?
By Jacob from Pegasus Lighting on May 29, 2013
Approximately 5.5in. The outside diameter is 6.5in.
By Frank from Santa Cruz, CA on October 3, 2013
How many degrees from vertical can this be tilted? Thanks in advance, Frank
By Jacob from Pegasus Lighting on October 3, 2013
It can be adjusted up to 28º from the vertical.